Programable Features:
- Dead Band Width
- Direction of Rotation
- Speed of Rotation (slower)
- End Points (up to 180 degrees)
- Neutral Points
- Fail Safe On/Off
- Fail Safe Points
- Resolution (default is set at high)
- Overload Protection (default is off)

Detailed Specifications

Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 4.8-7.4 Volt Peak to Peak Square Wave
Operating Voltage Range: 4.8-7.4 Volts
Operating Temperature Range: -20° to +60° C (-4°F to +140°F)
Operating Speed (6.0V): 0.16sec/60° at no load
Operating Speed (7.4V): 0.14sec/60° at no load
Stall Torque (6.0V): 122oz/in. (8.8kg.cm)
Stall Torque (7.4V): 139oz/in. (10.0kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Idle Current Drain (6.0V): 3mA at stop
Idle Current Drain (7.4V): 3mA at stop
Current Drain (6.0V): 200mA/idle and 2.0 amps at lock/stall
Current Drain (7.4V): 240mA/idle and 3.0 amps at lock/stall
Dead Band Width: 2usec
Motor Type: 3-Pole Ferrite (7.4V wind)
Potentiometer Drive: 6 Slider Indirect Drive
Bearing Type: Dual Ball Bearing MR106
Gear Type: Metal Gears
Connector Wire Length: 7" (178mm)
Dimensions: 1.6" x 0.8"x 1.5" (41 x 20 x 38mm)
Weight: 2.1oz (60g)

HS-5665MH Hardware Set

This servo can be configured to operate 180° by using any of the following servo programmers:
Hitec HFP-20 , HPP-21, HPP-21+