Setting the trim on any R/C car is crucial but perhaps even more critical is the trim remaining consistent throughout a
race. JConcepts introduces the servo mount bracket for the B5, B5M, T5M and SC5M series of vehicles. Constructed
of billet aluminum and available in either blue or black colors, this unique part offers benefits over the stock mount
configuration. 

First, the mount fits snug inside the chassis servo mounting area increasing the support across while the 2 screw
mounting locations are beefy in design and zeroed in for a direct mount to that chassis. Second, the bracket has
locations on each side for included 3x6mm setscrews to help align and maintain servo position during racing
conditions, crashes and hard hits. The set screws are intended to touch-off against the servo case and provide
additional support keeping the servo in the intended position which helps maintain consistent steering trim.

The servo mount bracket can be installed without any modifications or additional equipment in the 5 series of vehicles
 and immediately brings peace of mind to the detail oriented racer.  With a sleek wrap-around like design, silver edge
chamfering and etched JConcepts.net logo the bracket adds consistency with aesthetic appeal. JConcepts is, World
Proven Innovation and Design.

To install, completely remove servo from vehicle and remove standard mounts. With the servo horn already in the
correct position, align plastic shims as previously used on the servo. Install bracket to each side and loosely fasten
factory mounting screws with washers into the 4 locations and snug them. Now, center the servo between the bracket
and install the 3x6mm set screws on each side, use a light amount of thread locking material and snug them to touch
off and keep the servo in place.

Completely clamp the 4 mounting screws on the front side to lock servo position. Remember to always use a light about
of thread locking material when securing steel screws into aluminum mounts. Reinstall the servo to vehicle and trim out
and check EPA adjustments to complete assembly. 

Features:

• JConcepts original design and function 


• Machined aluminum, wrap-around concept 


• Setscrew controlled centering feature 


• Silver edge chamfering with etched logo


• Available in blue and black colors 


• Aesthetic jewelry