![](http://www.teamtekin.com/graphics/esc-featuresicon.gif) |
Ultra-smooth and Precise Throttle and Braking Control
Compatible with Sensored/Sensorless Brushless and Brushed Motors
Easily Access Programming, Anywhere, Anytime
Datalogging Capability
High Voltage Programmable BEC
EZ Access HotWire Programming Port
HotWire PC Interface for Advanced Programming and Updating
D2: Dual Drive Mode Technology
On-Board Temperature Indicator
Removable/Replaceable Cooling Fan
HDAC: High Density Copper PCB's
Sensor Plug for Precise Commutation with all Motors
Gold-plated Solder Posts for Easy Wire Replacement
Self Test Diagnostics and Factory Reset
Pit Tune Mode
DGF2: Digital Glitch Filtering V2
QuickTune¢â Programming
One-Touch Radio Calibration
30mm RX8 Fan Included #TT3832 >>view image
High airflow volume for extreme cooling
Impact resistant durable design for offroad applications
Brushless Motor |
![](http://www.teamtekin.com/graphics/esc-programfeaturesicon.gif) |
High Voltage BEC (6.0v/7.4v)*
Drag Brake (13 steps)
Brake / Reverse Strength (13 steps)
Current Limiter (none + 12 steps)
Neutral Width (13 steps)
Timing Profiles (5 preset - 2 custom*)
Adjustable Throttle and Brake Minimums
Custom Throttle Curves
Motor/Reverse Type: Brushless, Brushed, No Rev, Rev Delay
Voltage Cutoffs (none, 2S, 3S, 4S, 5S, 6S, Custom)
Save, Load and Share custom ESC setup files*
Save, Load and Share Data Log files*
Extensive Tuning via Tekin HotWire PC Interface
*Requires HotWire Sold Separately |
![](http://www.teamtekin.com/graphics/blank_spec_icon.gif) |
Controls: Forward/Brake/Reverse Input Voltage: 2S-6S Lipo Continuous Current: 220 Amps* BEC: 6.0v / 7.4v 7amps Motor Limit Brushless Mode: No Limit Motor Limit Brushed Fwd Only Mode: No Limit Motor Limit Brushed Fwd/Rev Mode: No Limit Max Current: 220amps per phase Timing Profiles: 7 choices (on board) Brushed Modes: Fwd Only, Fwd/Rev, Rev Delay Brushless Modes: Fwd Only, Fwd/Rev, Rev Delay Dimensions: 1.5 x 2.2 x 1.4in (38 x 55.8 x 25.5mm) Weight: 2.7oz / 76.5g
Tekin recommends LiPo batteries with at least a 40C discharge rate for 1:8 applications.
|